Search results for query: *

I have found my power seat switch is draining my battery over a day or so. It seems like the middle switch is not going back to the "neutral position". I am in an area with a lot of new homes being built and I think the trucks going by, shakes the car and the power seat tries to move and then...

I have replace all of the wiring on my 300 (thought it was a good idea at the time, but not sure now!) and still having problems with the fuel gauge reading. Before I tear it all apart I wanted to get an idea how it works or what to expect. Normally I expect a 12 v power going into the unit, a...

I thought purchasing a new modern Painless Mopar harness was going to be the answer to my electrical problems and maybe one day it will! I have found Painless of NO help and I use to think I understood car wiring. I thought I had all of the turning signals working, but then I ran into some...

Well, I am still working on the PainFULL wiring harness! I use to think I understood electrical diagrams! It could be age! I got lot/some of it done. The problem is figuring out what Painless harness does and what Chrysler does. 1) Painless expects 2 wires for the brakes and the 300 has...

I have a 1970 Chrysler 300 with Concealed Headlamps and I would like to re-wire it, so I need to understand how they work. I have disconnected the motor leads and I thought when one lead had power, that it would cause the unit to open and if I connected the battery to the other motor lead the...

I have had so many problems with my electrical, I decided to replace all of the wiring harness with Painless. What a mistake that has proven to be! Painless is NO help, so I am hoping I can get some from the forum. I thought I knew something about wiring as I did wire up a 36 Chev hot rod and...

I have removed all the old wiring and replaced it with a PainFull Wiring Harness. The harness is OK as far as it goes, but the section about Mopar is useless! There is nothing on the dash. I was hoping someone could tell me how to set up the charging gauge. They have nothing on warning light...

I have finally had it and I have purchase a Painless wiring harness (#10127)for my 1970 Chrysler 300. Every wire that I can, I will replace and then hopefully then the car will not stop in the middle of traffic for no reason! The problem with the harness and Painless, is there is no...

I am still trying to find out why my 300 convertible loses all it's power at times. Sunday, I was driving along with overcast skies and the engine stopped. I coast to the side of the road and no lights, ignition, radio, or any other power but the top. I tried a jumper pack, disconnected and...

The top on my Chrysler 300 has stopped going up and down. I het the switch and nothing. Manual says it has 30 amp fuse, but I cannot find the fuse. All of the fuses in the block are fine but none labelled Top. I really do not want to tear the car apart looking for a fuse. When I was not...

I have a rear seal link in my engine and have tried to fix it and get others to fix it. I have not found anyone that I would trust to work on it. If they do not return my calls, they do not want the job and people who cannot give me a time estimate, never done it before! I am thinking if I...

Well, I thought I would take the 300 for a run in the sun! I hate Chrysler electrical! The radio works, but when I turn the key on to start, sounds like the starter starts to engage and then I lose TOTAL power to the car. Radio, lights, nothing works. I disconnect the battery and reconnect...

My car has never had cruise control and I would like to install a cruise control kit. Where can I find one or what would the part number be? Any help would be appreciated!

My car has never had cruise control and I would like to install a cruise control kit. Where can I find one and what would the part number be? Any help would be appreciated!

I have been having some electrical problems with my 1970 Chrysler 300 Convertible and wondering: 1) if I should get a new wiring harness and if so where do you get one? 2) if I can get all of the relays and breakers that I need on my 300? 3) I am having a problem identifying electronic parts in...

I am feeling like something has gone wrong with my electrical, but I had some experts check it and they say all is fine. A few months or so ago my radio decided to stop working and now my power windows do not work. There does not appear to be any power at the switches. With the switches taken...

Can some one tell me where I can find a set of brown 300 door panels and the front bucket seat plastic back for a 1970 Chrysler 300 convertible?

My 300 has suddenly decided to get back at me for years of trouble free driving! Last week I went down to Blaine Washington for another gas run. Filled the 300 up and headed home, all seem great! I was driving down the highway about 60 mph, stopped at a light and the hit it to go up a long...

The rear seal was leaking on my 1970 Chrysler 300 brake drums, so I went to the parts shop to get a new seal. I was told to remove the old one and bring it in. I removed the seal and in doing so damaged the area with the part number. I can read 1546 but the parts people cannot match it...

I have now found that the bottom right fuse keep blowing, any time I start the car. When |I look at the charging gage when I start, it maxs out when I start then backs off to 3/4 way across. I check the battery while the car is running and it is 13.6 volts. I have replaced the alternator and...