Search results for query: *

Heya folks, I'm in a jam with my 66 at a shop and the front end on the ground.. My issue is lower ball joints..every supplier I've looked at has them listed as a post type similar to the uppers just not thread in. The lowers on my car are a post on an arm. Definitely not the same. They kind of...

Ok, so I am going to pull the trigger and put a fresh engine in my 66. While tired I get the impression that for my local cruising I don't need to build a stroker or anything overly fancy. I am also not doing a resto job on the car. Going with the eddy 750, electronic ignition and a good...

So it's 6am and I wake up thinking about what else...my car. Just had a thought someone else has probably had. My speedometer is in mph, I'm in Canada so kph is the standard. I've got that extra rear end from the 68..is there a gear set that I can swap in that will in a nutshell make my speedo...

So I've got a chance at two cars, both are going to scrap so I'm trying to get picker rights before they do. One is rather complete and I'm keeping the drive line. The other is much rougher. Looks like there is a lot of trim and bits still on them tho... So. I'll throw this out to the team. Lmk...

So my yorker has drums all the way around and the single pot master...found out last night that if your fluid gets a bit down that's a really bad thing..)) So..with brakes I'm not afraid of throwing money at it to be better, should I go disk in front only or disk all the way around? I've...

Don't do it, does NOT fit. Not even close. Upper hose is 6 inches farther from center. Overall width is much greater... Liland contact links are disabled and after spending 400 to rockauto on it I will end up getting 150 bucks back for returning it. Currently I've got my blown rad (rock...

I've got a 1966 yorker 440. It's pretty cleaned up and I'm starting the build and repairs to make it a daily tomorrow. So far I know it needs a new tank, a front motor mount and the power brake booster replaced. Red interior and that almost yellow body. No idea where I'm going to go with this...

Got one Location: Chilliwack