Search results for query: *

I can't for sure remember where the two studs go for BB valve covers, and I've looked at lots of pix....sometimes with differing results. :BangHead: I think the studs go in the outboard lower corners like I have marked here on my repro covers, but I've seen a pic or two of the studs in the two...

You'll recall my post here New valve covers from AMD. Quite nice! about my AMD valve covers, but as I mentioned, I'm moving to 8mm wires. This doesn't quite work with the OEM "rubbers" on the right side, so I hollowed-out [to 29/64ths] the brackets for the white plastic insulators (which then...

I'm replacing the MoPerf valve covers (and air cleaner and a bunch of other details) with correct-looking stuff, so I bit the bullet and ordered the AMD repro covers. Wow....pretty nice stuff. I'll be using 8mm wires, so I had to do a little work enlarging the wire looms (brackets) on the...

I'm getting ready to install the entire Inline Tube kit from tank to carb, to replace the "rubber hose and electric pump" treatment this car got in it's past, with a block-off plate where the fuel pump should be, so I have nothing to go by. I see several so-called OEM pumps out there, but what...