I am having issues with getting the alignment angles on my 73 Fury Wagon; can't get more than 1º caster even w/FirmFeel tubular Upper control arms, and one side maxes out at 0.5º negative camber
I have new bushings in the lower control arms on the strut rods, new Ball joints top, and bottom, & there doesn't appear to be any damage to the stub frame that could be impacting my alignment angles.
Also, I have rechecked my ride height and it was approximately 1" lower than what the FSM specifies, but have now readjusted it.
That slight decrease in ride height couldn't throw off the angles that much could it?
I am also hoping someone can confirm that I have not mistakenly installed the arms onto the wrong sides? UCA's in the picture were removed/installed from the driver side. Thanks in advance
I have new bushings in the lower control arms on the strut rods, new Ball joints top, and bottom, & there doesn't appear to be any damage to the stub frame that could be impacting my alignment angles.
Also, I have rechecked my ride height and it was approximately 1" lower than what the FSM specifies, but have now readjusted it.
That slight decrease in ride height couldn't throw off the angles that much could it?
I am also hoping someone can confirm that I have not mistakenly installed the arms onto the wrong sides? UCA's in the picture were removed/installed from the driver side. Thanks in advance