t57f100
Member
hello all putting my rear main seal in my 65 plymouth fury 318 motor do you guys use any sealer in that block area and does someone have a pic of where to put sealer on that location.
hello all putting my rear main seal in my 65 plymouth fury 318 motor do you guys use any sealer in that block area and does someone have a pic of where to put sealer on that location.
my fault i should have stated its a 2 piece rubber seal fel pro
its out on a standIs the engine in or out of the car?
Dave
its out on a stand
Once, I tried the sneaky Pete type of method. Once. It was a shitshow.It is always a better choice to pull the crank and use the appropriate tools to mold the seal to the bearing journal, but the sneaky pete is probably also a viable alternative choice.
trying to move forward here got seal in place now putting oil pump in does the oil pump need a gasket between the pump and the bearing cap i have heard a thin gasket i have heard of a o ring and people running nothing its a 318 65 plymouth fury poly motor stock book states put back together tighten it down im stumped
i see it took a quick pic of itMost of the stock 318 poly engines used an o-ring between the pump and the mount point. Look at your pump, it should have a small recess to hold the o-ring. Photo is attached, click on Mail0141.PDF, not the icon.
Dave
my god thank youMost of the stock 318 poly engines used an o-ring between the pump and the mount point. Look at your pump, it should have a small recess to hold the o-ring. Photo is attached, click on Mail0141.PDF, not the icon.
Dave