source for new fuel line

[traintech55]

I did my fuel and brake lines on jack stands. That was the great part of buying them pre bent,

 

[live4theking]

I'm still a fan of doing them yourself... try a few practice flares until you are satisfied... lots of cheap bending tools available... supplies are cheap... most of all I am cheap.

Me too!

 

[live4theking]

I did my fuel and brake lines on jack stands. That was the great part of buying them pre bent,

Me too!

Now I'm not doing a restoration so I cheated a little in that I used Ni-Copp lines for the brakes. I pulled all of the lines and then worked in the other stall of the garage. Cut the line a little long then bad some measurements from one end into the longest straight section. Marked my new line a few inches longer than that in, taped the new piece of line to the straight section and then bent either end. Trimmed the line to length, put fittings on and flared the ends. Everything fit pretty good for it being the first time I'd ever done it.