DC118us
Member
Hi all, I've been lurking around this site for years, but don't post often.
I have a 75 T&C, 440/727, etc. Bone stock except the carburetor.
After the long cold winter, I've developed an issue I'm hoping you guys can help me with...
I got in her and turned the key to the run position and the starter began cranking. Turned it off then back on and it only cranked in the start position. Shut her down and went to start it again, same thing, starter cranks in run position. I rapped the steering column and it quit. Started right up and ran good, but while running, the starter engaged again.
I think it's my ignition switch in the column, but I'm looking for some expert advise, rather than guessing. Quick search for a replacement ignition switch doesn't show much, due to it being the tilt/tele setup.
Anyone run into an issue like this before and what fix is there?
Dino
I have a 75 T&C, 440/727, etc. Bone stock except the carburetor.
After the long cold winter, I've developed an issue I'm hoping you guys can help me with...
I got in her and turned the key to the run position and the starter began cranking. Turned it off then back on and it only cranked in the start position. Shut her down and went to start it again, same thing, starter cranks in run position. I rapped the steering column and it quit. Started right up and ran good, but while running, the starter engaged again.
I think it's my ignition switch in the column, but I'm looking for some expert advise, rather than guessing. Quick search for a replacement ignition switch doesn't show much, due to it being the tilt/tele setup.
Anyone run into an issue like this before and what fix is there?
Dino