Firstly, I hope you've all had a nice Christmas ![Thumbs Up :thumbsup: :thumbsup:](https://www.forcbodiesonly.com/mopar-forum/styles/default/xenforo/smilies/ATT00014.gif)
My question to you, should the pressed out stock steel rockers be a nice snug fit to the shaft, maybe a few thou clearance or so ?
I know all the aftermarket stuff is either bushed or needle bearing, so I guess the stock set up is similar in intention to have a smooth rocking motion but no real play ?
I've looked though the manual I have but not seeing any spec for ware or serviceable clearance ? have I over looked it ?
I'll wait until I have a few comments / opinions before I say why I may have concerns
Thanks guys![Thumbs Up :thumbsup: :thumbsup:](https://www.forcbodiesonly.com/mopar-forum/styles/default/xenforo/smilies/ATT00014.gif)
![Thumbs Up :thumbsup: :thumbsup:](https://www.forcbodiesonly.com/mopar-forum/styles/default/xenforo/smilies/ATT00014.gif)
My question to you, should the pressed out stock steel rockers be a nice snug fit to the shaft, maybe a few thou clearance or so ?
I know all the aftermarket stuff is either bushed or needle bearing, so I guess the stock set up is similar in intention to have a smooth rocking motion but no real play ?
I've looked though the manual I have but not seeing any spec for ware or serviceable clearance ? have I over looked it ?
I'll wait until I have a few comments / opinions before I say why I may have concerns
Thanks guys
![Thumbs Up :thumbsup: :thumbsup:](https://www.forcbodiesonly.com/mopar-forum/styles/default/xenforo/smilies/ATT00014.gif)