Search results for query: *

I have 2935873 remote driver side mirror. I think it's 1969-1970 Plymouth based on internet research. P# does not appear in my 1969-1971 parts books. Can anyone confirm? If not, tell me what it fits? Thanks,

I have bought a set of Road Wheels for my 1970 Plymouth Fury convertible. I took them and my Cooper tires to a service station to have the tires mounted and balanced. I thought the trim rings would cover up the front balance weights. And I thought there would be room for the weights under the...

I have a loft above the 1970 Fury convertible and the 1972 Fury Coupe that are in my garage. I had a piece of angle iron stored too close to the edge of that loft. Because the asphalt shingles on the roof were mostly black and eaten up with moss, I had roofers come in and reshingle the roof. The...

I am going to put road wheels on my 1970 Plymouth Fury convertible. I bought a set in South Carolina and am starting to paint them to get them ready. So far I am using POR 15 gloss black chassis paint on the rear and sides. I know the center front should be Argent Silver. Are you all just taping...

If you look at the 1st 2 pictures you can see that the previous owner of my car put aftermarket tint on the side and rear glass. There are 2 problems with this tint. The 1st is that it was so dark that I couldn’t see out the rear window at night, using the rear view mirror. The 2nd is...

Plymouth Fury Dash Shell: I would like to know if from 1971 to 1972 the positions of the 4 mounting screws that go through the defroster vents and the 2 bolts, one behind each kick panel changed. My guess is that the fuselage passenger compartment is the same but I’m not sure. I ask the question...

Over the course of 2020 I built and installed 440/727 in my 1970 Fury. The car is a blast to drive! However, the old rule: "projects uncover need for other projects", still applies. So I went to the gas station and filled up the tank with premium. Not sure when the car was last at a gas station...

My 72 Fury has these studs coming out of rubber blocks, which extend into the trunk. Any idea of what torque to use on the nuts? I was guessing 10'lbs. Don't want to overtighten. BSM gives vague directions and no torque specs for any bumper bolt. Thanks, Ben No torque specs at end of...

I need to paint the plastic under-column panel so it comes out looking like this picture. Tried Krylon gold, but it looked like a new penny. Any suggestions on a matching gold spray paint? Thanks, Ben

I do not have a car with a vinyl top. However, I wanted to know for a man who is just replacing the vinyl top, can the windshields and stainless trim stay in place? If so, does the installer carve out the old vinyl that is under the stainless with a utility knife? Or some other tool? I guess...